Filter
Top Products
8
Setup
Installing the Weight
Parts needed for this step:
Description
Qty.
Nut, Nyloc 3/8-16 Flg ........................... 2
Weight ................................................. 1
Screw, Button Head 3/8-16 x 1............. 2
Asm, Weight Support ........................... 1
Rod, Weight, Lock................................ 1
Procedure:
The front weight installed without the
bagger may cause loss of traction and
steering control or an unstable
condition which could result in injury
or death.
Install the front weight only when the
bagger is installed.
Note: The removable weight is heavy.
Use care when lifting it. Make sure that
you can hold it securely before lifting it.
Use caution when positioning your hands
so that you do not set it down on your
hands or fingers.
1. Attach the weight support assembly
(item 5) to the front panel foot rest with
two 3/8-16 x 1 button head screws
(item 4) and two nyloc nuts (item 2) as
shown in Figure 4.
Figure 4
1. Front panel foot rest 2. Nut
3. Weight 4. Screw
5. Weight support assembly 6. Weight lock rod
7. Oval hole
Note: If your mower does not have mounting
holes on the foot rest, position the back of the
weight support assembly on the cross bar
under the foot rest. Center the weight support
assembly and mark the two mounting holes
on the lip of the foot rest. Drill holes using a
13/32” drill bit. Install weight support
assembly as stated in step 1.
2. Insert the weight (item 3) onto the weight
support assembly (item 5).
3. The lock rod (item 6) has a key on one end.
Slide the lock rod through the weight support
assembly, notch in the weight and the oval
hole in the frame bracket.
4. Rotate the lock rod to secure it into place.
Note: The weight support assembly can stay
mounted to the unit when the bagger and
weight are removed.
Installing the Hitch Bracket
Parts needed for this step:
Description
Qty.
Bolt, Carriage 3/8-16 x 5...................
.
4
Plate, Stiffener..................................
.
4
Nut, Nyloc 3/8-16 Flg........................
.
8
Tube, Bagger....................................
.
2
Bolt, Carriage 3/8-16 x 3...................
.
4
Plate, Stiffener..................................
.
2
Hitch, Bagger....................................
.
1
Procedure:
1. Remove the two 3/8-16 carriage bolts at the
rear of each frame rail. Retain for reuse if the
bagger is removed.