Filter
Top Products
10
If you remove the spring-loaded hood
when it is closed (in the down
position), the hood may suddenly fly
open and you or someone else may be
bruised, pinched, or injured in another
way.
Always open (raise) the hood before
you remove or install it on the quick-
attach bracket.
3. Install the bags by sliding the bag frame
hooks onto the retaining brackets.
Figure 7
1. Retaining bracket 2. Bag frame hook
4. Lower the hood onto the bags. Then push
down on both bagger retainer latches until
they lock on the bag frame as shown in
Figure 8.
Figure 8
1. Hood 2. Bagger retainer latches
Installing the Boot Mount Bracket
and Tubes
Parts needed for this step:
Description
Qty.
Nut, Nyloc 5/16-18 Flg ...................... 1
Bkt, Boot Mount ................................ 1
Asm, Lower Tube.............................. 1
Bolt, Carriage 5/16-18 x 3/4 .............. 1
Asm, Upper Tube.............................. 1
1. Remove the discharge deflector from the
deck. Retain all components for reuse if the
bagger is removed.
2. Install the boot mount bracket (item 2) onto
the deck frame using the 5/16-18 x 3/4
carriage bolt (item 3) and nyloc nut (item 1) as
shown in Figure 9. Bracket may stay on when
converting to side discharge mode.
Figure 9
1. Nut 2. Boot mount bracket
3. Screw 4. Mount bracket
5. Lower tube 6. Rubber latch
7. Upper tube
3. Insert the tab on the lower tube assembly into
the boot mount bracket as shown in Figure 9.
4. Use the latch on the lower tube assembly to
lock the bracket to the deck. Adjust the
tension on the latch to hold the bracket up to
the deck, yet allow for release by hand.
5. Slip the upper tube into seal of the hood
opening – push in and then pull out so that
the seal is extended outward.
6. Slide the upper tube onto the lower tube and
fasten the rubber latches (Figure 9).