Filter
Top Products
- 28 -
5.1.11 Check hydraulic oil level
:
Service Interval: 40 hr.
a) Stop engine and wait for all moving parts to stop.
b) Clean area around hydraulic reservoir cap and remove cap. Oil level
should be to the top of the baffle inside the tank. If not, add oil. Use only
Mobil 1 15W-50 synthetic motor oil. Replace hydraulic reservoir cap and
tighten until snug. Do not overtighten.
NOTE: The baffle has two levels. The upper level represents the “HOT”
level and the lower level represents the “COLD” level. The oil level varies
with the temperature of the oil. The “HOT” level shows the level of oil when
it is at 225°F (107°C). The “COLD” level shows the level of the oil when it is
at 75°F (24°C). Fill to the appropriate level depending upon the
temperature of the oil. For example: If the oil is about 150°F (65°C), fill to
halfway between the “HOT” and “COLD” levels. If the oil is at room
temperature (about 75°F (24°C)), fill only to the “COLD” level.
5.1.12 Check tire pressures
:
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Check tire pressure in drive tires.
c) Inflate drive tires to 10 psi (90 kPa).
d) Semi-Pneumatic Caster tires (without a valve stem) do not need to be
inflated.
NOTE: Do not add any type of tire liner or foam fill material to the tires.
Excessive loads created by foam filled tires may cause failures to the hydro drive
system, frame, and other components. Foam filling tires will void the warranty.
5.1.13 Check condition of belts
:
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat up. Lift the rubber flap on front side of the
engine to check pump drive belt.
c) Remove left and right belt shields on deck and lift up floor pan to inspect
deck drive belt.
d) Check under machine to inspect the mule drive belt.
e) See Sections 5.2.3, through 5.2.5 for belt adjustment.
5.1.14 Lubricate grease fittings
:
Service Interval: Refer to chart.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Lubricate fittings with one to two pumps of NGLI grade #2 multi-purpose
gun grease.
Refer to the following chart for fitting locations and lubrication schedule.