Filter
Top Products
Figure 10
Using Your Ceiling Fan
IMPORTANT
Fan installation must be completed,
including the installation of the fan
blades, before testing of the controls.
1. Restore electrical power to the outlet
box by turning the electricity on at the
main fuse box or circuit breaker panel.
2. Check the operation of the fan by
sliding the bar of the control through the
four positions marked 1 - 4 (“0” position
is OFF) (Figure 10).
3. All fans are shipped from the factory
with the reversing switch positioned to
circulate air downward. If airflow is
desired in opposite direction, turn your
fan OFF and wait for the blades to stop
turning, then slide the reversing switch
to the opposite position, and turn fan on
again (Figure 11).
4. The fan blades will turn in the opposite
direction and reverse the airflow.
4
0
3
2
1
Figure 11
REVERSE SWITCH
8
Model No.: CF3400
7. Attach the fan control to the wall outlet
box with two 6-32 x 3/4” screws
(provided with control).
8. Position the wall plate (provided with
control) onto the speed control. Using
the two 6-32 x 1/4” screws, fasten the
wall plate to the control (Figure 9).
9. Installation of the ceiling fan is now
complete. Restore power at the main
fuse box or circuit breaker panel.
TO NEUTRAL
TO FAN MOTOR LOAD
TO 120VAC
SOURCE
HOT
BLACK
BLACK
4
0
3
2
1
Figure 8
4
0
3
2
1
6-32 x 1/4"
SCREW (2)
WALL PLATE
SW46 FAN CONTROL
OUTLET BOX
6-32 x 3/4"
SCREW (2)
Figure 9
BP7386, CF3400 Corsair 11/25/09 6:20 AM Page 8