Filter
Top Products
BLADE
(Sold Separately)
#10-32 x .75"
OVAL HEAD
SCREW
(3 per blade
assembly)
BLADE
MEDALLION
MEDALLION BOSS
(3 per medallion)
Figure 6
2. Assemble the remaining blade per
previous instructions.
NOTE: Take care not to scratch fan
blades during installation.
This control is designed to operate only
one ceiling fan.
WALL PLATE
WALL OUTLET BOX
SWITCH
Figure 7
4. Connect one BLACK wire from the fan
control to the fan/motor load wire
with a wire connector (provided)
(Figure 8).
5. Connect the other BLACK wire from the
Fan Control to the 120VAC hot supply
wire with a wire connector (provided
with control).
NOTE: Use wire connectors (supplied)
to secure electrical connections.
6. If present, connect the supply white
neutral wire to the branch circuit white
neutral wire with a wire connector.
How to Wire Your Ceiling
Fan - SW46 Wall Control
7
Model No.: CF3400
1. Remove the wall plate and screws from
the existing wall switch. Pull switch out
from wall outlet box.
2. Disconnect wire from existing fan wall
switch (Figure 7).
3. Slide the fan control to the OFF position
(0).
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
!
WARNING
To avoid possible fire or shock, follow all
wiring instructions carefully. Any
Electrical work not described in these
instructions should be done or approved
by a licensed electrician.
!
WARNING
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker panel.
NOTE: If you are not sure if the outlet box
is grounded, contact a licensed
electrician for advise, as it must be
grounded for safe operation.
!
WARNING
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
!
WARNING
BP7386, CF3400 Corsair 11/25/09 6:20 AM Page 7