Filter
Top Products
www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!"X!!!!!!!!!!!!!!!!#$%$#!&'!()*!+,-.!/01203!456
EditProg - RecCntrl - Execution [continued]
To start a Auto Program please proceed as follows:
1. Slave-Setting
• Select “Function Mode” by turning the encoder.
• Press the Enter button to confirm.
• Select “Set to slave” by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select “Slave 1”, “Slave 2” or “Slave 3”.
• Press the Enter button to confirm.
• Press the MODE/ESC button in order to return to the main menu.
2. Automatic Program Run
• Select “Function Mode” by turning the encoder.
• Press the Enter button to confirm.
• Select “Auto Program” by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select “Master” or “Alone”. The selection "Alone" means Stand Alone-mode
and "Master" that the device is defined as master.
• Press the Enter button to confirm.
• Press the MODE/ESC button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select “Edit program” by turning the encoder.
• Press the Enter button to confirm.
• Select “Select programs” by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select “Auto Pro Part 1”, “Auto Pro Part 2” or “Auto Pro Part 3”, and thus select
which Slave program is to be sent. Selection “Part 1” means, that the Slave unit runs the same
program as the master units.
• Press the Enter button to confirm.
• Press the MODE/ESC button in order to return to the main menu.
4. Program selection for Edit Program
• Select “Edit program” by turning the encoder.
• Press the Enter button to confirm.
• Select “Edit program” by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select the desired program. With this function you can edit specific scenes into
a specific program.
• Press the Enter button to confirm.
• Press the MODE/ESC button in order to return to the main menu.
5. Automatic Scene Recording
• Select “Edit program” by turning the encoder.
• Press the Enter button to confirm.
• Select “Edit scenes” by turning the encoder.
• Turn the encoder to select the desired scene numbers, you can program a max number of 250
• Press the Enter button to confirm.
• Press the MODE/ESC button in order to return to the main menu.