Filter
Top Products
www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!"W!!!!!!!!!!!!!!!!#$%$#!&'!()*!+,-.!/01203!456
EditProg - EditScen
Edit the scenes of the internal programs.
1 Access the main menu by pressing MODE/ESC.
2 Press the UP/DOWN buttons until “EditProg” is displayed and press ENTER.
3 Press UP/DOWN buttons until “EditScen” is displayed and press ENTER.
4 Press UP/DOWN buttons to select desired Scene number (Scen001-Scen250), and
press ENTER to confirm selection.
5 Press UP/DOWN buttons to select desired function (Auto, Red, Gree, Blue, Whit,
Stro, Dimm, Macr, Temp, ScenTime, InByOut), and press ENTER to confirm
selection.
6 Press UP/DOWN buttons to select desired value (001-250) and press ENTER to
confirm selection.
7 Press MODE/ESC to return to previous menu or display will automatically exit.
EditProg - RecCntrl
This fixture features an integrated DMX-recorder by which you can transmit the programmed
scenes from your DMX-controller to the moving head. Adjust the desired scene numbers via
the encoder (from – to). When you call up the scenes at your controller, they will
automatically be transmitted to the moving head.
EditProg - RecCntrl - Execution
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can
start 3 different Slave units, which run 3 different programs. The Master unit sends the 3
program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave
unit was assigned to. If e.g. a Slave unit is set to “Slave 1” in the menu “Set to Slave”, the
Master unit sends “Auto Program Part 1” to the Slave unit. If set to “Slave 2”, the Slave unit
receives “Auto Program Part 2”.