Filter
Top Products
8
1. POWER HEAD - Factory assembled. Includes the engine, clutch, fuel system, ignition system and starter.
2. GRIP - Rear (right hand) handle.
3. FRONT HANDLE - The front handle can be repositioned for comfortable operation by loosening the screws and
moving the handle.
4. SHAFT DECAL (See page 3)
5. SHAFT DECAL (See page 3)
6. DEBRIS SHIELD/FLAP - Mounted over the cutting attachment. Helps protect operator by deflecting debris
produced during the edging operation.
7. BLADE - Rotates to provide cutting action.
8. WHEEL - Adjustable up/down, sets depth of blade.
9. DRIVE SHAFT ASSEMBLY - Contains a specially designed liner and the flexible drive shaft.
10. THROTTLE TRIGGER - Spring loaded to return to idle when released. When accelerating, press trigger gradually
for best operating technique.
11. STOP SWITCH - "TOGGLE SWITCH" mounted on the engine. Move switch UP to RUN, DOWN to STOP.
12. CHOKE - The choke control is located on the air filter case. Move lever to "COLD START" (
) to close choke for
cold starting. Move lever to "RUN" ( ) position to open choke.
13. SPARK PLUG - Provides spark to ignite fuel mixture.
14. ARM REST - Protects arm from the hot engine.
15. SPARK ARRESTOR - CATALYTIC MUFFLER / MUFFLER -The muffler or catalytic muffler controls exhaust noise
and emission. The spark arrestor screen prevents hot, glowing particles of carbon from leaving the muffler. Keep
exhaust area clear of flammable debris.
16. FUEL TANK - Contains fuel and fuel filter.
17. FUEL TANK CAP - Cover and seals fuel tank.
18. I-30 RECOIL STARTER/HANDLE - i30 spring-assisted recoil starter requires 30% less pulling force than standard
recoil starter. Pull handle slowly until starter engages, then quickly and firmly. When engine starts, return handle
slowly. DO NOT let handle snap back or damage to unit will occur.
19. PURGE BULB - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging air from the
carburetor. Pump purge bulb until fuel is visible and flows freely in the clear fuel tank return line. Pump purge bulb
an additional 4 or 5 times.
20. AIR CLEANER ASSEMBLY - Contains replaceable felt element.