Filter
Top Products
22
BLADE REPLACEMENT
Level 1
Tools Required: Locking tool, pliers, T-Wrench
Parts Required: Blade P/N 69601553630, new split pin
P/N 90030020022
NOTE
Replace blade when it is worn shorter than 6 inches.
1. Remove split pin (A).
2. Align hole in inner blade adapter (B) with notch in gear housing,
and insert locking tool to prevent PTO shaft (C) from rotating.
3. Remove L.H. blade nut (D) by turning clockwise. Remove outer
blade adapter (E), and blade (F).
4. Install and center blade (F) on inner blade adapter (B).
5. Install outer adapter (E) and nut (D). Tighten nut (D) firmly,
turning counterclockwise.
IMPORTANT
Never reuse old split pin.
6. Install new split pin (A) to secure nut, and bend both legs of pin
counterclockwise around PTO shaft.
B
C
A
E
F
D