Filter
Top Products
10
THROTTLE LINKAGE
1. Manually pivot throttle rotor (B) clockwise until rotor stops, and
hold in place.
2. Insert throttle cable (C) through adjustment fixture (D).
3. Align slot in carburetor pivot (E) with throttle cable. Large hole in
side of pivot must face away from adjustment fixture.
4. Place cable into slot, and squeeze trigger slowly to seat cable end in
large hole. Release throttle rotor and trigger.
5. Depress trigger, and check for smooth throttle operation:
IDLE POSITION: Rotor must rest against idle adjustment screw (F)
when throttle is released.
WOT POSITION: Rotor must stop against adjustment fixture (G)
when throttle trigger is fully depressed.
NOTE
Consult with your Echo Dealer for correct adjustment procedure.
WARNING DANGER
Cutting attachment must not move at idle. If attachment moves,
see Carburetor Adjustment section page 19.
B
C
D
E
F
G