Filter
Top Products
8
CS-400
NOMENCLATURE OF PARTS
1. Instruction manual - Included with unit. Read be-
fore operation and keep for future reference to learn
proper, safe operating techniques.
2. Safety manual - Describe operating and safety
instructions for this chain saw.
3. Front hand guard - Guard between the front handle
and the saw chain for protecting the hand from
injuries and aiding in control of the chain saw if the
hand slips off the handle.This guard is used to lock
the chain brake which is to stop the saw chain rota-
tion.
4. Cleaner cover knob - Device for installing the air
cleaner cover.
5. Air cleaner cover - Covers air lter.
6. Purge pump - When starting engine, push purge
pump 3 or 4 times.
7. Choke control knob - Device for enriching the fuel/
air mixture in the carburetor to aid cold starting.
8. Rear hand guard - Extension on the lower part of
the rear handle for protecting the hand from the
chain if it breaks or degrooves.
9. Clutch cover - Protective cover to the guide bar,
saw chain, clutch and sprocket when the chain saw
is in use.
10. Chain tension adjuster - Device to adjust chain
tension.
11. Chain catcher - A projection designed to reduce the
risk of the operator’s right hand from being hit by a
chain which has broken or derailed from the guide
bar during cutting.
12. Spiked bumper - Device, tted in front of the guide
bar mounting point, acting as a pivot when in con-
tact with a tree or log.
13. Guide bar - The part that supports and guides the
saw chain.
14. Saw chain - Chain, serving as a cutting tool.
15. Bar tip guard - Anti-kickback device attached on
the bar nose.
16. Cylinder cover - The cooling airow grill. It covers
the cylinder, spark plug and silencer.
17. Front handle (for the left hand) - Support handle
located at the front of the engine housing.
18. Oil tank cap - For closing the oil tank.
19. Starter handle - Pull handle slowly until starter en-
gages then quickly and rmly. When engine starts,
return handle slowly. DO NOT let handle snap back
or damage to unit will occur.
20. Fuel tank cap - For closing the fuel tank.
21. Throttle trigger - Device activated by the operator’s
nger, for controlling the engine speed.
22. Rear handle (for the right hand) - Support handle
located towards the rear of the engine housing.
23. Throttle trigger lockout - A safety lever which must
be depressed before the throttle trigger can be acti-
vated in order to prevent the accidental operation of
the throttle trigger.
24. Ignition switch - Device for connecting and discon-
necting the ignition system and thus allowing the
engine to be started or stopped.
25.Sparkarrestormuferorsparkarrestormufer
with catalyst -The mufer or catalytic mufer con-
trols exhaust noise and emission. The spark arres-
tor screen prevents hot, glowing particles of carbon
from leaving the mufer. Keep exhaust area clear of
ammable debris.