Filter
Top Products
31
1 2
4
5
6
3
1
2 3
4
6
5
Cleaning the guide bar,
lubricating the sprocket nose
CAUTION: Protective gloves must be worn.
Regularly inspect the bearing surfaces of the guide bar for
damage, and clean them with a suitable tool.
If the saw is used intensively it will be necessary to lubricate the
return sprocket bearings regularly (once a week). To do this, rst
thoroughly clean the 2 mm hole at the tip of the guide bar, and
then press in a small amount of multi-purpose grease.
Multi-purpose grease and grease guns are available as acces-
sories.
Multi-purpose grease (order number 944 360 000)
Grease guns (order number 944 350 000)
A
B
Cleaning the sprocket interior, checking and
replacing the chain catch sleeve
CAUTION: Before doing any work on the guide bar or chain,
always switch off the engine and pull the plug cap off the
spark plug (see „Replacing the spark plug“). Always wear
protective gloves!
CAUTION: Do not start the saw until it has been completely
assembled and inspected!
Remove the sprocket guard (4) (see section on „PUTTING INTO
OPERATION“ A – B) and clean the interior with a brush.
Remove the chain (3) and guide bar (2).
NOTE:
Make sure that no residue or contaminants remain in the oil
guide groove (1) and the chain tightener (6).
For replacing the guide bar, chain, and sprocket see „PUTTING
INTO OPERATION“.
Chain catch sleeve
Visually inspect the chain catch sleeve (5) for damage and
replace if necessary.
Remove the sleeve by rmly pulling it upwards and off; then
push on the new sleeve.
PS-3410 TH
PS-3410 TH (TLC)