Filter
Top Products
6
H
G
7
6
5
9
8
30 m (100 feet)
3 meters
= wearing Protective Equipment
- Always wear safety shoes or boots (G) with steel toes,
non-skid soles, and leg protectors when working with the Power
Cut. Safety shoes equipped with a protective layer provide
protection against cuts and ensure a secure footing.
- Always wear a work suit (H) of tough material with sufficient
flame-retardant qualities whenever working with the cutoff saw.
Fuels / Refuelling
- Go to a safe, level place before refuelling. Never refuel while
on scaffolding, on heaps of material, or in similar places!
- Switch off the engine before refuelling the Power Cut.
- Do not smoke or work near open fires (6).
- Let the engine cool down before refuelling.
- Fuels can contain substances similar to solvents. Eyes and skin
should not come in contact with mineral oil products. Always
wear protective gloves when refuelling (not the regular work
gloves!). Frequently clean and change protective clothes. Do
not breathe in fuel vapors. Inhalation of fuel vapours can be
hazardous to your health.
- Do not spill fuel. If a spill occurs, clean off the Power Cut
immediately. Fuel should not come in contact with clothes. If
your clothes have come in contact with fuel, change them at
once.
- Ensure that no fuel oozes into the soil (environmental protec-
tion). Use an appropriate base.
- Refuelling is not allowed in closed rooms. Fuel vapors will
accumulate near the floor (explosion hazard).
- Ensure to firmly tighten the screw cap of the fuel tank.
- Before starting the engine, move to a location at least 3 meters
(approx. 10 feet) from where you fuelled the Power Cut (7), but
not within the extended swing range of the cutting disc (direction
of sparks).
- Fuel cannot be stored for an unlimited period of time. Buy only
as much as will be consumed in the near future.
- When making up the gasoline/oil mixture, always put the oil in
the mixing container
first, and then the gasoline.
- Use only approved and marked containers for the transport and
storage of fuel.
- Keep fuel away from children!
Putting into operation
- Do not work on your own. There must be someone around
in case of an emergency (within shouting distance).
- Observe all anti-noise regulations when working in residential
areas.
- Never use the Power Cut near inflammable materials or
explosive gases! The Power Cut can create sparks leading
to fire or explosion!
- Make sure that all persons within 30 meters (100 feet), such as
other workers, are wearing protective gear (see "Protective
Equipment") (8). Children and other unauthorized persons must
remain more than 30 meters (100 feet) away from the working
area. Keep an eye out for animals as well (9).
- Before starting work the Power Cut must be checked for
perfect function and operating safety according to the
prescriptions. In particular, make sure that the cutting wheel is
in good condition(replace immediately if torn, damaged or
bent), the cutting wheel is properly mounted, the protective
hood is locked in place, the hand guard is properly mounted, the
V-belt has the proper tension, the throttle moves easily and the
half-throttle lock button functions properly, the grips are clean
and dry, and the combination switch functions properly (Start/
Stop (I/O) switch, choke).
- Start the Power Cut only after complete assembly and inspec-
tion. Never use the Power Cut when it is not completely
assembled.