Filter
Top Products
11
Maintenance
- Before performing maintenance work switch off the Power
Cut (27) and pull out the plug cap.
- Always check the Power Cut before using it to make sure that
it is in good working order. In particular, make sure that the
cutting disc is properly mounted. Make sure that the cutting
wheel is undamaged and suitable for the job it will be used for.
- Operate the Power Cut only at a low noise and emission level.
For this ensure the carburetor is adjusted correctly.
- Clean the Power Cut regularly.
- Check the fuel tank cap regularly for good sealing.
Observe the accident prevention instructions issued by
trade associations and insurance companies. NEVER
make any modifications to the Power Cut! You will only
be putting your own safety at risk!
Perform only the maintenance and repair works described in
the instruction manual. All other work must be carried out by
DOLMAR Service.
Use only original DOLMAR spares and accessories.
The use of non-DOLMAR spares, accessories, or cutting
discs increases the risk of accident. We cannot accept any
responsibility for accidents or damage occurring in associa-
tion with the use of cutting discs or accessories other than
original DOLMAR.
First aid
For the event of a possible accident, please make sure that a
first aid kit is always immediately available close by. Immedi-
ately replace any items used from the first aid box.
When calling for help, give the following information:
- Place of the accident
- What happened
- Number of injured people
- Kind of injuries
- Your name!
NOTE
Individuals with poor circulation who are exposed to excessive
vibration may experience injury to blood vessels or the nervous
system.
Vibration may cause the following symptoms to occur in the
fingers, hands or wrists: ”Falling asleep” (numbness), tingling,
pain, stabbing sensation, alteration of skin colour or of the skin.
If any of these symptoms occur, see a physician!
27
28
29
SERVICE
STOP