Dolmar HT-2556 D, HT-2576 E Brush Cutter User Manual


  Open as PDF
of 20
 
9
B
C
Refuelling
FOLLOW THE SAFETY PRECAUTIONS!
Be careful and cautious when handling fuels.
Refuel only with the engine switched off and cooled
down!
Thoroughly clean the area around the caps, to prevent dirt from
getting into the fuel tank.
Unscrewthetankcapandllthetankwithfuelmixtureuntil
itreachesthebottomedgeofthellerneck.Becarefulnotto
spill fuel when pouring.
Screw the tank cap back on hand tight.
After refuelling, clean the tank cap and area, and check
for leaks!
fuel/oil mixture
Starting position for the HT-2556 D
Start the trimmer only after it has been completely as-
sembled!
Move at least 3 meters (10 feet) away from where you fuelled
the trimmer. Make sure you have a secure footing, and place
the trimmer on the ground (cutter to the left).
Thetipofyourrightfootshouldbermlyplacedintherear
handguard.
Graspthefrontgriprmlywithyourlefthandandtipthetrimmer
away from yourself until you feel resistance (the cutter will be
lifted slightly so that it is not touching the ground).
Do not use any other starting method!
Starting position for the HT-2576 E
Start the trimmer only after it has been completely as-
sembled!
Move at least 3 meters (10 feet) away from where you fuelled
the trimmer. Make sure you have a secure footing, and place
the trimmer on the ground (cutter to the right).
Thetipofyourrightfootshouldbermlyplacedonthefront
grip.
Graspthereargriprmlyfromthetopwithyourlefthandand
tip the trimmer away from yourself until you feel resistance
(the cutter will be lifted slightly so that it is not touching
the ground).
Do not use any other starting method!
 previous next