Dolmar HT-2556 D, HT-2576 E Brush Cutter User Manual


 
13
D
E
F
STOP
Checking the mufer bolts /
cleaning the exhaust outlet
Caution:
Do not tighten the mufer bolts when the engine is hot!
Themuferbolts(
6) are directly accessible so they can be
checked for tightness. If loose, hand-tighten (caution: do not
over-tighten).
Regularly clean the exhaust outlet (7) with a suitable tool.
Checking the ignition spark
Use insulated pliers to hold the loose spark plug (5), with the
sparkplugcaprmlyattached,againsttheenginehousing(away
from the spark plug hole!).
Put the ON/OFF (I/O) switch in the “I” position.
Pull the starter cable hard.
If the function is correct, an ignition spark must be visible near
the electrodes.
CAUTION: Use only the following spark plug: NGK BPMR
7A.
Replacing the spark plug
CAUTION:
Do not touch the spark plug or plug cap if the engine is
running (high voltage).
Switch off the engine before starting any maintenance work.
A hot engine can cause burns. Wear protective gloves!
The spark plug must be replaced in case of damage to the
insulator, electrode erosion (burn) or if the electrodes are very
dirty or oily.
Pull the plug cap (4) off the spark plug. Use only the combination
wrench supplied with the saw to remove the spark plug.
Electrode gap
The electrode gap must be 0,6 - 0,7.