Filter
Top Products
Page 12
CHASSIS: 11 GA - rectangular tube
BODY: Two piece - made of high-density polyethylene. Front body contains
access panels for battery service and engine to mower deck belt
removal. Rear body tilts up to allow service on the entire drive system.
SEAT: Designed for operator comfort by use of high density closed cell foam
padded back and arm rests, upholstered with Cordura
TM
water-repellent
fabric. Seat is adjustable fore and aft.
MOWER DECK: 2 Decks are available. 60" is made of stamped steel. 50" is made of
11 GA fabricated welded construction with external reinforcement
ribs. 3 blades combine for either a 50" or 60" cut width. Cut height
approximately 1.5" to 4.5" via 7 position lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L
Series 70 hydrostatic transmission. The hydrostatic transmissions, in
turn, power a fully enclosed HydroGear gearbox.
ENGINE: 23HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve, Air-
Cooled, Gasoline, Vertical Shaft, Aluminum Head, and Crankcase with
Cast Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type
Fuel Pump, Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition,
In-Line Fuel Filter, Dual Element Air Cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
TIRES: Front 11 X 4 X 5 ribbed tread
Rear 20 X 10 X 8 Multi Trac
RECOMMENDED Front 16 - 21 lbs.
TIRE PRESSURE: Rear 8 - 14 lbs.
CAPACITIES: Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 36
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS: Width 60"(50" Deck), 72"(60" Deck)
Height 45"
Length 72"
Weight 680 lbs.(50" Deck), 685 lbs.(60" Deck)
NOTE:
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Model ZTR 5023
SPECIFICATIONS