11Page
SPECIFICATIONS
Model ZTR 5020
CHASSIS: 11 GA - rectangular tube
BODY: Two piece - made of rotational molded polyethylene. Front body
contains access panels for battery service and engine to mower deck
belt removal. Rear body tilts up to allow service on the entire drive
system.
SEAT: Designed for operator comfort by use of high density closed cell foam
padded back rest and arm rests, upholstered with Cordura
TM
water-
repellent fabric. Seat is adjustable fore and aft.
MOWER DECK: 2 Decks are available. 60" is made of stamped steel. 50" is made of
11 GA fabricated welded construction with external reinforcement
ribs. 3 blades combine for either a 50" or 60" cut width.
Cut height approximately 1.5" to 4.5" via 7 position lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L
Series 70 hydrostatic transmission. The hydrostatic transmissions, in
turn, power a fully enclosed HydroGear gearbox.
ENGINE: 20HP Briggs & Stratton Intek, overhead valves, replaceable oil filter,
full pressure lube system, dual element air cleaner, integral fuel pump.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
TIRES: Front 11 X 4 X 5 smooth profile
Rear 20 X 10 X 8 Multi Trac
RECOMMENDED Front 16 - 21 lbs.
TIRE PRESSURE: Rear 8 - 14 lbs.
CAPACITIES: Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 36
Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS: Width 60"(50" Deck), 73"(60"Deck)
Height 45"
Length 72"
Weight 668 lbs. (50" Deck), 685 lbs. (60" Deck)
NOTE: Additional information provided in service instructions under the
individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE