Desa SPC-21PHTSA Patio Heater User Manual


 
www.desatech.com
114082-01F8
8. Apply air pressure into the venturi tube
(with cone on end) to remove dust, lint or
spider webs.
9. Reinstall burner assembly to base as-
sembly.
CABINET
Air Passageways
Use a vacuum cleaner or pressurized air to
clean.
Exterior
Use a soft cloth dampened with a mild soap
and water mixture. Wipe the cabinet to re-
move dust.
STORAGE
1. Allow at least 45 minutes for heater to cool
down after using.
2. Store heater upright in a sheltered area
away from inclement weather and dust.
3. If desired, cover heater after heater has
cooled.
4. If heater is not to be used for an extended
period of time, disconnect and remove
propane/LP gas cylinder and store in ac-
cordance with the Standard for Storage
and Handling of Liquefied Petroleum
Gases, ANSI/INFPA 58.
CLEANING AND
MAINTENANCE
Continued
SERVICING
To assure safety, proper function and lon-
gevity of the heater, regular maintenance is
required. The frequency of maintenance will
depend on the usage of the unit. Review the
following concerning the criteria for a properly
functioning heater. Failing to follow proper,
regular maintenance will void warranty.
A hazardous condition may result if a heater
is used that has been modied or is not func-
tioning properly. When the heater is working
properly:
The flame is contained within the heater.
The flame is essentially blue with perhaps
some yellow tipping.
There is no strong disagreeable odor, eye
burning or other physical discomfort.
There is no smoke or soot internal or ex-
ternal to the heater.
There are no unplanned or unexplained
shut downs of the heater.
The parts lists and wiring diagram show the
heater as it was constructed. Do not use a
heater which is different from that shown.
In this regard, use only the hose, regula-
tor and cylinder connection fitting (called
a POL fitting) supplied with the heater.
IMPORTANT: Do not use alternates. For this
heater, the regulator must be set as shown
in Specifications, page 2. If there is any
uncertainty about the regulator setting, have
it checked.