Filter
Top Products
www.desatech.com
114082-01F 5
PRODUCT
IDENTIFICATION
Figure 1 - Propane/LP Table Top Patio
Heater
Dome
Reflector
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system.
The ODS/pilot is a required feature for table
top patio heaters. The ODS/pilot shuts off the
heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
UNPACKING
1. Remove heater from carton.
2. Remove all protective packaging applied
to heater for shipment.
3. Check heater for any shipping damage.
If heater is damaged, promptly return to
dealer where you bought heater.
ASSEMBLY INSTRUCTIONS
Tools Required:
• Phillips Head Screwdriver
• Standard Pliers
Inspect heater components for possible ship-
ping damage. If any is found, immediately
notify the dealer. Check to make sure that all
components are included with your heater
(see pages 12 and 13).
1. Attach burner and controls assembly to
base assembly with 4 screws (see Fig-
ure 3). Tighten screws. Place operating
instruction label under control knob for
easy review.
2. Align 3 dome holes with the 3 studs pro-
truding from burner top (see Figure 3).
Place dome onto the studs. Install 3 cap
nuts onto studs. Tighten with pliers.
The installation must conform with local codes
or in the absence of local codes, The National
Fuel Gas Code, ANSI Z223.1.
Figure 3 - Heater Assembly
Figure 2 - Clearances from Combustibles
16"
(40.64 cm)
Wire
Guard
Propane/LP
Cylinder
Housing
Base
Control
Knob
16"
(40.64 cm)
16"
(40.64 cm)
30" (76.20 cm)
Below Burner
Dome
Reflector
Cap Nuts
Burner and
Controls
Assembly
Base
Assembly
Screws