Filter
Top Products
28 se ct iO n 7— se r v ic e
Replacing the Belt
Remove the deck from beneath the tractor, (refer to Deck
Removal on page 24).
Remove the hex washer screws securing the belt covers to 2.
the deck and loosen the belt keepers enough to slide the
Install the new belt around the spindle pulleys as shown in 4.
Fig. 7-8 and reinstall the belt covers.
Reinstall the deck following the instructions in Deck 5.
Installation on page 26.
Mower Blade Care
WARNING!
gloves when handling the blades. When servicing
the mower deck, be careful not to cut yourself on
the sharpened blades.
cutting edges of the blades evenly so that the blades remain
balanced and the same angle of sharpness is maintained.
If the cutting edge of a blade has already been sharpened many
times, or if any metal separation is present, it is recommended
that new blades be installed. New blades are available at your
authorized dealer.
The blades may be removed as follows.
Remove the deck from beneath the tractor, (refer to Deck
Removal on page 25) then gently flip the deck over to
expose its underside.
Hex Washer
Screws
Belt Cover
Belt Keeper
Figure 7-9
Use a 2. ⁄
assembly when loosening the hex nut securing the blade.
A block of wood may be placed between the deck housing
and the cutting edge of the blade to help in breaking loose
the hex nut securing the blade.
To reinstall the blades, reverse the above process and 4.
Reinstall the deck (refer to Deck Installation on page 265. ).
NOTE: Add a small amount of multi-purpose grease to the
bolt threads to avoid corrosion and galvanic action.
WARNING!:
that are bent should be replaced. The cutting blades
are sharp and can cause severe injury. Wrap the
cutting surface of the blade with a rag to avoid
injury.
Sharpening the Blades
Remove the deck from beneath the tractor, (refer to Deck
Removal on page 25) then gently flip the deck over to
expose its underside.
Clean any debris from the blades. Keep blades sharp and
free of build up at all times.
2.
balanced cutting blades. Do not sharpen the underside of
the blades. Use a electric blade sharpener, a conventional
electric grinder or a hand file to sharpen the blades.
Replace any blade with severe nicks or dents that cannot
be removed by filing.
Check the balance of the blade after sharpening by placing 4.
it on a blade balancer. Do not use unbalanced blades.
If the blade dips on one end, file stock off of the cutting 5.
surface on that end.
NOTE:
Hex Washer
Screw
Spindle Assembly
Blade
Flange Lock Nut
Hex Nut
Figure 7-10