Filter
Top Products
6 se c t i O n 2 — iM p O r t a n t sa f e Op e r a t i O n pr a c t i c e s
5.
tree limbs, clothes lines, and other obstacles that otherwise
lines, guy wires, and buildings, could create hazardous
conditions whereby the machine could experience a tip-
over or roll-over. The canopy can provide protection for
the operator from some environmental exposure (sunlight,
rain, etc.). Work lights may be available.
6.
and should not be tampered with, modified in any manner,
or removed.
7.
and therefore the operator must be aware of potential
doorways, clothes lines, utility wires, etc., that could cause
the machine to upset or rollover. Use caution in (or avoid)
structures, trees, etc.
8.
caution when operating on slopes.
basis for damage and improper operation. Replace all
components that are damaged or are not functioning
properly with authorized replacement parts.
Fail ure to use the seat belt properly could result in serious
injury or death if an accidental overturn occurs. In order
fastened around the operator at all times when the
an overturn could cause serious injury or death.
overs.
machine.
Hydraulic Devices and Systems
draulic fluid escaping under pressure may have sufficient force
to penetrate skin and to cause serious injury. If foreign fluid is
injected into the skin, it must be surgically removed within a few
hours by a doctor familiar with this form of injury, or gangrene
may result.
WARNING: Keep body and hands away from
pinholes or nozzles that could eject hydraulic fluid
under high pressure. Use paper or cardboard, not
hands, to search for leaks!
e all pressure in the system before performing any
work on the system, and make sure that:
The key is removed
The engine spark plug wire(s) removed
All connections to the negative terminal of the battery are
removed
The park brake is set
All by-pass valves, if so equipped, are open
lic controls are actuated to release pressure on
pumps, cylinders, etc. If “float” positions are available, they
should be used.
After the above operations are completed, it should be safe to
begin disconnecting the lines or components. It is still a good
idea to cover the connection with a cloth shield and then gently
loosen connections.
WARNING: Make sure all hydraulic fluid
connections are tight and all hydraulic hoses and
lines are in good condition before applying pressure
to the system.
Service
Related to Fuel
Fuel is highly flammable and its vapors can explode if
Do not smoke or permit others to smoke while handling 2.
fuel.
Always use approved containers for fuel and fill slowly
to decrease the chance of static electricity buildup and
spillage.
4.
away from sparks and flames.
When dispensing fuel into approved containers, place the 5.
container on the ground when refueling to avoid a possibel
static electricity ignition of fuel vapors.
Do not fill containers while it is inside a vehicle, trunk, bed 6.
of a pickup or floor of the trailer.
Always shut off the engine and permit it to cool before 7.
removing the fuel tank cap.
Always fill the fuel tank outdoors.8.
If the fuel container spout will not fit inside the fuel tank
opening, use a funnel.
When filling the fuel tank, stop when the fuel reaches
one inch from the top. The space is necessary for tank
Wipe up any spilled fuel.
General Service
Never run an engine indoors or in a poorly ventilated area.
Engine exhaust contains carbon monoxide, an odorless,
and deadly gas.
2.
blade(s) and all moving parts have stopped. Disconnect the
spark plug wires and remove the key from the ignition to
prevent unintended starting.
complete stop within approximately (5) five seconds after
operating the blade disengagement control. If the blades
do not stop within the this time frame, your machine
should be serviced.