Cub Cadet Tank S S7232D Lawn Mower User Manual


  Open as PDF
of 52
 
15se c t i O n 4 — cO n t r O l s a n d fe a t u r e s
completed according to the instructions in this manual and the
engine manual.
Throttle Control


engine speed will be maintained. The trottle control moves
between the fast
and slow positions.

speed. The tractor is designed to operate with the throttle
control in the fast position
(full throttle) when the tractor is
being driven and the mower deck is engaged.

speed.
Parking Brake
The parking brake is located on the left side
of the tractor and to the left side of the brake

down at the same time until it latches to engage

and release to disengage the parking brake.
NOTE: If the speed control pedals are not in the
neutral position when engaging the parking
brake, the engine will stop. The parking brake
must be placed in the engaged position when starting the
tractor engine.
Fuel Tank Cap
The fuel tank caps are located on top of the fuel tanks. Turn the
cap and pull upward to remove.

clockwise to tighten. Always re-install the fuel cap tightly onto
the fuel tank after removing.
Transmission Bypass Valves (Not Shown)

transmission) are located just in front of the engine and just
behind the seat.
When engaged, the two valves open a bypass within the
hydrostatic transmissions, which allows the tractor to be pushed
short distances by hand. Refer to the Maintenance & Adjustments
section for instructions on using the bypass feature.
CAUTION: Never tow your tractor. Towing the
tractor with the rear wheels on the ground may
cause severe damage to the transmissions.
BR
AK
E
Speed Control Pedals
The speed control pedals are located
on the right side of the traction unit.
The speed control pedals must be in the
neutral position to start the tractor engine.


reverse pedal causes the mower to move
backward. Consequently, these pedals
control all of the movements of the tractor.
Driving and steering utilizing these control
pedals is quite different from conventional tractors, and will

instructions on using the speed control pedals.
Ignition Switch


switch has three positions as follows:

off.
RUN — The tractor electrical system is energized.

key immediately when the engine starts
NOTE: To prevent accidental starting and/or battery discharge,
remove the key from the ignition switch when the tractor is not
in use.
PTO (Power Take-Off) Switch


ignition switch.

clutch mounted on the bottom of the engine


downward to disengage the clutch.

position when starting the engine.
Digital Tachometer and Hour Meter


hours that the tractor has been operated in the digital display.

reminders (oil, lube) in the digital display.
The tachometer/hour meter is activated whenever the ignition

hours of operation to assure all maintenance procedures are
Forward
Pedal
Reverse
Pedal
OFF
RUN
START
 previous next