Filter
Top Products
33se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s
Turn the new filter cartridge approximately 7. ⁄-turn
clockwise to lock.
NOTE: The lock icons on the body and cartridge should be
aligned or nearly aligned.
Remove the clamp from the fuel line. The filter should 8.
begin to fill will diesel fuel.
begins to seeps out around the bleed knob. Turn the air
bleed knob clockwise to close.
Remove the catch container and properly dispose of the
diesel fuel.
to fully bleed any residual air from the filter, fuel lines, and
injection pump.
Tractor Storage
If your tractor is not going to be operated for an extended period
of time (thirty days to approximately six months), the tractor
protected location. If stored outside, cover the tractor (including
the tires) to protect it from the elements. The procedures
outlined below should be performed whenever the tractor is
placed in storage.
Change the engine oil and filter following the instructions
provided in the engine manual packed with this manual.
WARNING! Never store the tractor with fuel in the
tank indoors or in poorly ventilated enclosures,
where fuel fumes may reach an open flame, spark or
pilot light as on a furnace, water heater, clothes
dryer, etc.
2.
To prevent gum deposits from forming inside a.
malfunction of the engine, the fuel system must be
either completely emptied, or the gasoline must be
treated with a stabilizer to prevent deterioration.
WARNING! Fuel left in the fuel tank deteriorates
and will cause serious starting problems.
Using a fuel stabilizer:b.
and recommendations.
Add to clean, fresh gasoline the correct
amount of stabilizer for the capacity
Fill the fuel tank with treated fuel and run the
into the carburetor.
Emptying the fuel system:c.
fuel consumption with the goal of running
the fuel tank empty.
Close the fuel tank shutoff valve. Disconnect
the fuel line from the carburetor and put the
end into an approved fuel container.
fuel tank and line into the approved container.
Reinstall the fuel line on the carburetor.
This will prevent gum and varnish deposits
from forming. Replace the fuel filter.
Remove the spark plugs and pour approximately one
ounce of oil into each cylinder. Crank the engine one or
two turns to spread the oil evenly on the cylinder walls.
Replace the spark plugs.
Clean the engine and the entire tractor thoroughly.4.
NOTE: Use of a pressure washer or garden hose is not
recommended to clean your tractor. They may cause
damage to electrical components, spindles, pulleys,
bearings or the engine. The use of water will result in
shortened life and reduce serviceability.
5.
when needed.
6.
oil on any unpainted surfaces including the pulleys and
Clean and fully charge the battery, then disconnect the 7.
negative cable at the battery to prevent possible discharge.
Recharge the battery periodically when in storage.
NOTE: Remove the battery if exposed to prolonged periods
where temperatures are above freezing.
Lubricate all lubrication points.8.
Inspect the hydraulic hoses, lines and fittings. Replace as
necessary.
off of the tires.