Filter
Top Products
30 se c t i O n 6— Ma i n t e n a n c e & ad j u s t M e n t s
Tire Maintenance
Check the tire air pressure before each use. Inflation pressure
of the rear tires is important for stability while the mower is in
operation. If the tire diameter is not equal between the two tires,
the mower will pull to one side. Keep the tires inflated to the
recommended pressures. Improper inflation will shorten the tire
Do not inflate a tire above the maximum pressure shown
on the sidewall of the tire.
Do not reinflate a tire that has been run flat or seriously
service the tire.
maintain straight travel (see tire side wall for proper
inflation pressure).
Keep the valve caps tightened to prevent air pressure loss.
Inflation Pressure
Leaking Tires
When a flat tire occurs, repair or replace immediately. The normal
procedure is to remove the wheel and replace it. If a tire is
getting soft, park the mower on the nearest level, paved area.
Rear Tire
a.
wheel and jack up the tire that leaks about an inch
off the ground.
Loosen and remove the lug nuts and remove the b.
wheel.
Mount a wheel and tire, replace the lug nuts, and c.
ft-lbs.
Front wheel2.
a.
and raise the caster wheel so that the tire is an inch
off the ground.
Loosen and remove the locknut from the axle b.
assembly and pull the axle assembly from the yoke.
The wheel and two spacer sleeves will drop free.
c.
through a spacer sleeve, a wheel, the other spacer
sleeve and finally through the other side of the yoke.
Tighten the locknut on the end of the axle assembly.d.
Lower the mower off the jack and continue mowing. e.
Contaminants or foreign matter in the oil will also damage the
pumps . To prevent this:
Use a filter that captures particles as small as 25 microns or
25 millionths of a meter in diameter.
the hydraulic system. Thoroughly clean off any component
before you work on it.
or plastic plug.
Use plastic caps to seal off the ends of hydraulic fittings.
Clean your hands frequently when working on the
hydraulic components.
NOTE: The pumps are not owner-repairable. If a pump fails,
Hydraulic System
Hoses
Check the hoses from the hydraulic oil tank to the oil filter to
the hydraulic lines daily for leaks or abrasion and replace any
damaged hoses. Make certain there are no kinks or twists in any
hose. Look for a flattened condition or any leaks and repair or
replace as necessary. A flattened or leaking suction hose will
permit cavitation to develop which can destroy the pumps in a
short time.
General Battery Information
WARNING!
the eyes or onto the skin, rinse the affected area
immediately with clean cold water. If there is any
further discomfort, seek prompt medical attention.
If acid spills on clothing, first dilute it with
clean water, then neutralize with a solution of
ammonia/water or baking soda/water.
NEVER connect (or disconnect) battery
charger clips to the battery while the charger is
turned on, as it can cause sparks.
Keep all sources of ignition (cigarettes,
matches, lighters) away from the battery. The gas
generated during charging can be combustible.
As a further precaution, only charge the
battery in a well ventilated area.
Always shield eyes and protect skin and
clothing when working near batteries.
emit explosive gases. Use extreme caution when
handling batteries. Keep batteries out of the reach
of children.