Filter
Top Products
7
Figure 5
3
Figure 6
Figure 7
CAUTION: Prior to operating your
snow thrower, refer to Auger Control
Test in Operation section. Read and
follow all instructions carefully, and
perform all adjustments to verify your snow thrower
is operating safely and properly.
Shear Pin Storage
Holes are located in the plastic dash panel for convenient
shear pin storage. See Figure 7.
IMPORTANT: This unit is shipped with
the engine full of oil. After assembly,
refer to engine manual for fuel and oil
fill-up details.
Chute Clean-Out Tool
The clean-out tool is conveniently fastened to the rear of
the auger housing with a mounting clip. See Figure 8.
1. Release both the auger control and the drive/auger
control lock.
2. Stop the engine by moving the throttle to the stop
position.
3. Remove the clean-out tool from the mounting clip.
4. Use the shovel-shaped end of the clean-out tool to
remove any snow and ice in the chute assembly.
5. Re-fasten the clean-out tool to the mounting clip on
the rear of the auger housing and restart engine.
6. While standing in the operator’s position (behind the
snow thrower), engage the auger control for a few
seconds to clear any remaining snow or ice from the
chute assembly before continuing to clear snow.
WARNING: Never use your hands to
clean snow and ice from the chute
assembly or auger housing.
Tire Pressure
The tires are over-inflated for shipping purposes. Check
the tire pressure before operating the snow thrower. Refer
to the tire side wall for tire manufacturer’s recommended
psi and deflate (or inflate) the tires as necessary. NOTE:
If the tire pressure is not equal in both tires, the unit may
not travel in a straight path and the shave plate may wear
unevenly.
Under any circumstance do not exceed manufactur-
er’s recommended psi. Equal tire pressure should
be maintained at all times. Excessive pressure when
seating beads may cause tire/rim assembly to burst
with force sufficient to cause serious injury. Refer to
sidewall of tire for recommended pressure.
WARNING
Prior to operating your
snow thrower, refer to
Auger Control Test in
Operation section. Read
and follow all instructions
carefully and perform
all adjustments to verify
your unit is operating
safely and properly.
Setting Up
Your Snow
Thrower
Figure 8
#HUTE#LEANOUT4OOL
Never use your hands to
clean snow and ice from
the chute assembly or
auger housing.
IMPORTANT: Under any
circumstance do not
exceed manufacturer’s
recommended psi. Equal
tire pressure should be
maintained at all times.
Excessive pressure when
seating beads may cause
tire/rim assembly to burst
with force sufficient to
cause serious injury.
Refer to sidewall of tire for
recommended pressure.