Filter
Top Products
16
6
Maintaining
Your Snow
Thrower
WARNING
Always stop engine,
disconnect spark plug,
and ground against
engine before performing
any type of maintenance
on your machine.
Figure 24
Auger Belt
1. Roll auger belt off the pulley as shown in Figure 23.
2. a. Turn the shoulder screw a half a turn and slide it out
of the mounting bracket. See Figure 24.
b. Unhook spring to release tension on the auger belt.
See Figure 24.
3. Remove old belt and replace with new belt wrapping it
around the auger pulley. See Figure 25.
4. Re-insert shoulder screw into the mounting bracket
and tighten to secure.
5. Wrap auger belt behind the idler. Reattach the spring
to the bolt where it was earlier secured.
6. Re-install frame cover and flip the snow thrower back
to the operating position.
7. Re-install auger belt around the engine pulley.
8. Re-install belt cover with the self-tapping screws
removed earlier.
Figure 25
Figure 23
"
!