Filter
Top Products
HydrostaticTransmission
Keep the area around the transmission cooling fan free
of grass and debris at all times. The hydrostatic ,_
transmission is sealed at the factory and is
maintenance free. The fluid level cannot be checked
and on most models, cannot be changed.
Ifyour tractor is equipped with a transmission drain plug
(see Figure 23), exposed to extreme conditions (hilly _1_
terrain, towing, etc.) and you choose to change the
hydrostatic fluid, do so after the tractor's initial 50 hours
of operation and every 100 hours of operation
thereafter.
NOTE: Several tractor components and parts (fender,
fuel tank, etc.) must be removed in order to refill the
transmission after draining it.
DrainPlug
NOTE: View shown from beneath tractor, i
Figure 23
After draining the oil, refill the transmission with 76 oz.
(to the top of the fill hole found on the transmission's
surface) with any SAE 20W50 motor oil.
Changingthe DeckBelt
WARNING: Be sure to shut the engine off,
remove ignition key, disconnect the spark
plug wire(s) and ground against the engine to
prevent unintended starting before removing
the belt(s).
WARNING: Avoid the possibility of a
pinching injury. Do not place your fingers on
the idler spring or between the belt and a
pulley while removing the belt.
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT:The V-belts found on you r tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. Fora proper working machine,
use factory approved belts.
To change or replace the deck belt on your tractor,
proceed as follows:
• Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
• Remove the belt guards by removing the self-
tapping screws that fasten them to the deck.
42-inch Decks
• Remove the belt keeper rod from around the
engine pulley.
• Insert a 3/8"-drive ratchet wrench (set to loosen)
into the square hole found in the idler bracket on
the left side of the deck's surface. See Figure 24.
Idler Bracket
Belt Guard
1
3/8"SquareH01e
J
Figure 24
Grasp the ratchet's handle and pivot it toward the
front of the tractor to relieve tension on the belt.
With belt tension relieved, carefully remove the
belt from around the left-hand spindle pulley.
27