Filter
Top Products
44
• Clamp the fuel line just to the rear of the fuel
filter. See Figure 60.
Figure 60
• Open the filter drain and drain the filter into the
container below. Close the filter drain.
• Turn the filter approximately 1/4 turn counter-
clockwise (as viewed from bottom) to align the
unlock icons. Refer to Figure 60.
• Pull the filter cartridge straight downward to
remove from the filter body.
• Align the unlock icons of the new filter cartridge
and filter body, and push the new filter cartridge
fully up into the filter body.
• Turn the new filter cartridge approximately 1/4
turn clockwise to lock. NOTE: The lock icons
on the body and cartridge should be aligned or
nearly aligned.
• Remove the clamp from the fuel line. The filter
should begin to fill will diesel fuel.
• Slowly turn the air bleed knob counterclockwise
until fuel begins to seeps out around the bleed
knob. Turn the air bleed knob clockwise to
close. Refer to Figure 60.
• Remove the catch container and properly
dispose of the diesel fuel.
• Start and run the tractor’s engine for a short
period to fully bleed any residual air from the
filter, fuel lines, and injection pump.
ENGINE BREATHER SERVICE
The engine breather should be changed after every
2000 hours of engine operation. Contact your Cub
Cadet dealer.
FUEL INJECTOR NOZZLE SERVICE
The fuel injector nozzles should be checked and
serviced after every 2000 hours of engine
operation. Contact your Cub Cadet dealer.
AIR BLEED
FILTER
FILTER
CARTRIDGE
KNOB
Clamp
Fuel Line
FUEL
LINE
LOCK/
UNLOCK
ICONS
DRAIN