Filter
Top Products
5
MAINTENANCE
1. Before dismounting tractor or performing any service or
maintenance, disengage power to implement, lower the 3-
point hitch and all raised components to the ground, operate
valve levers to release any hydraulic pressure, stop engine,
set parking brake, remove key, and unfasten seat belt.
2. Never work under a raised loader. Always lower loader to the
ground with bucket or loader attachment in full roll-back posi-
tion. Shut off tractor, set park brake and remove key. Operate
valve levers to release any hydraulic pressure.
3. Adjustment of system relief pressure should be done by a
qualified, experienced Cub Cadet Yanmar dealer. Incorrect
adjustment can result in system failures and serious personal
injury.
4. Always wear relatively tight and belted clothing to avoid
entanglement in moving parts. Wear sturdy, rough-soled work
shoes and protective equipment for eyes, hair, hands, hearing
and head.
.5 Do not allow other people in the area when operating, attach-
ing, removing, assembling or servicing equipment.
6. Ensure implement is properly attached, adjusted and in good
operating condition.
7. Keep all persons away from operator control area while
performing adjustments, service or maintenance.
8. Tighten all bolts, nuts and screws securely. Check that all
cotter pins are installed securely to ensure equipment is in a
safe condition before operating.
9. Ensure all safety labels are installed. Replace if damaged.
(See Safety Labels later in this section)
10. Ensure shields and guards are properly installed and in good
condition. Replace if damaged.
11. Do not disconnect hydraulic lines until all system pressure is
relieved. Lower unit to ground, stop engine, and operate all
hydraulic control levers.
12. When servicing or replacing pins in cylinder ends, buckets,
etc., always use a brass drift and hammer. Failure to do so
could result in injury from flying metal fragments.
STORAGE
Block equipment securely for storage. Stored loader can fall and
cause serious injury or death. Securely store loader and attach-
ments to prevent falling. To help prevent injury caused by a falling
implement, always:
1. Detach on a hard, level surface.
2. Keep children and bystanders away
3. Engage the tractor’s parking brake before detaching from
storage area.
To provide necessary balance, loader frame must be equipped
with bucket or attachment before attaching or detaching from
tractor, or when loader is in stored position.
1. Do not loosen hydraulic fittings or hoses while loader is in
stored position.
2. Do not climb or lean on equipment stored on stand.
WARNING! YOUR RESPONSIBILITY
Restrict the use of this attachment to persons who read, understand and follow the warnings and instructions in this manual,
the tractor’s Operator’s Manual and on the tractor and loader attachment. The safety labels found on the loader attachment
are illustrated on the following page.