Filter
Top Products
18
• Grasp the PTO idler pulley bracket and pivot it
toward the discharge chute to relieve tension
on the belt. Remove the deck belt from around
the electric PTO clutch and the PTO idler
pulley.
NOTE: On units equipped with a 46-inch deck, the
bottommost belt on the deck does NOT need to be
removed in order to remove the deck.
• Looking at the cutting deck from the right side
of the tractor, locate the deck support pin on
the rear right side of the deck.
• Pull the deck support pin outward to release
the deck from the deck lift arm. See Figure 14.
• Rotate the pin slightly toward the rear of the
tractor and release the pin into the hole
provided.
• Repeat the above steps on the left side of the
tractor.
• Move the lift lever into the top notch on the
right fender to raise the deck lift arms out of
the way.
• Gently slide the cutting deck toward the front
of the tractor allowing the hooks on the deck
to release themselves from the deck stabilizer
rod. Do NOT let the deck fall to the ground.
• Gently slide the cutting deck (from the right
side) out from underneath the tractor.
NOTE: To properly remount the cutting deck,
perform the above steps in reverse order. Having a
second person assist you will ease this procedure.
Figure 14
CHANGING THE DECK BELT(S)
All belts on your tractor are subject to wear and should be replaced if any signs of cracking, shredding or
rotting are present.
IMPORTANT: The V-belts found on your tractor are specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the deck belt(s) on your tractor, proceed as follows:
NOTE: Removing the deck from the tractor as instructed earlier in this section will ease the following steps,
but is not necessary.
42-inch decks
• Lower the deck by moving the lift lever into the bottom notch on the right fender.
• Remove the belt guards by removing the self-tapping screws that fasten them to the deck surface.
• Grasp the PTO idler pulley bracket and pivot it toward the discharge chute to relieve tension on the belt.
• Remove the deck belt from the electric PTO clutch and from around the PTO idler pulley.
Deck Support Pins
Deck
Stabilizer
Bracket
Deck Stabilizer Rod
Deck Lift Arms
Electric PTO Clutch
PTO Idler Pulley Bracket
To Lift Assembly
Front of Tractor
NOTE: Belt covers and other tractor components not shown for clarity. 42-inch deck shown
Hooks
(mounted on tractor)
PTO Idler Pulley
PTO Belt