Filter
Top Products
SERVMCEA
i_rlrl................... i i ,,,,,,,,i.............................. i,llll
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 21)
The mower' blade drive belt may be replaced without tools_
Park the tractor on level surface° Engage parking brake.
BELT REMOVAL-
= Remove mower from tractor (See '`TO REMOVE
MOWER" in this section of this manual)
° Work belt off both mandrel pulleys and idler pulleys.
= Pull belt away from mower_
BELT INSTALLATION -
° Install new belt in reverse order of removal
= Make sure belt is inall pulley grooves and inside all belt
guides.
° Install mower in reverse order of removal instructions.
MANDREL
PULLEY
IDLER
PULLEYS
ADJUSTMENTS
WITH PARKING BRAKE "ENGAGED"
MANDREL
PULLEY
FIG. 21
TO ADJUST BRAKE (See Fig. 22)
Your tractor is equipped with an adjustable brake system
which is mounted on the right side of the transaxte.
If tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted.
o Depress clutch/brake pedal and engage parking brake..
• Measure distance between brake operating arm and
nut "A" on brake rod°
If distance is otherthan 1-1/2", loosen jam nut and turn
nut "A" until distance becomes 1-1/2'L Retighten jam
nut against nut "A"..
Road test tractor for proper stopping distance as stated
above° Readjust if necessary. If stopping distance is
still greater' than six (6) feet in highest gear, further
maintenance is necessary. Contact your nearest au-
thorized service center'.
NUT "A"
JAM
NUT
OPERATING
ARM
FIG. 22
TO REPLACE MOTION DRIVE BELT
(See Fig. 23)
Park the tractor on level surface_ Engage parking brake_
For assistance, there is a belt installation guide decal on
bottom side of left footrest.,
• Remove mower' (See "TO REMOVE MOWER" in this
section of this manuaL)
° Remove upper belt keeper,
= Remove belt from stationary idler and clutching idler.
° Pull beft slack toward rear of tractor. Remove belt
upwards from trartsaxle pulley by deflecting belt keep-
ers,
° Pull belt toward front of tractor and remove downwards
from around engine pulley_
° Install new belt by reversing above procedure°
IMPORTANT: MAKE SURE UPPER BELT KEEPER IS
POSITIONED PROPERLY BETWEEN LOCATOR TABS.
PULLEY
CLUTCHING
IDLER
IDLER
TABS
BELT
KEEPER
TRANSAXLE
PULLEY
22 FIG. 23