Filter
Top Products
CUSTOM RESPONS
BATTERY
Your tractor has a battery charging system which is suffi-
cient for normal use., However, periodic charging of the
battery with an automotive charger will extend its life.
• Keep battery and terminals clean°
o Keep battery bolts tight.,
o Keep small vent holes openr
o Recharge at 6-10 amperes for I hour.
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battew and terminals can cause
the battery to "leak" power,
o Remove terminal guar&
° Disconnect BLACK battery cable first then RED bat-
tery cable and remove battery from tractor.,
• Rinse the battery with plain water and dry.
• Clean terminals and battery cable ends with wire brush
until brighL
. Coat terminals with grease or petroleum jelly.
° Reinstall battery (See "CONNECT BATTERY" in the
Assembly section of this manual).,
V-BELTS
Check V-belts for deterioration and wear after 100 hours of
operation and replace if necessary. The belts are not
adjustable. Replace belts if they begin to slip from wean
TRANSAXLE COOLING
Keep transaxle free from build-up of dirt and chaff which
can restrict cooling,
ENGINE
LUBRICATION
Only use high quality detergent oil rated with AP! service
classification SF or SG_ Select the oil's SAE viscosity grade
according to your expected operating temperature,
SAE VISCOSITY GRADES ..............
i_F _20_ 0° 30" 320 40" 60 _ 800 'i00 _
.........., ' ' i
i°c-3oo -20o 40° oo _;o 2oo 3oo 40°
TEM,P,gRATuRE'RANGEANTiciPATED BEFORENEXTOILCHANGE
NOTE: Although multi-viscosity oils (5W30, 10W30 etc,)
improve starting in cold weather, these multi-viscosity oils
wil! result in increased oil consumption when used above
32°F, Check your engine oil level more frequently to avoid
possible engine damage from running low on oil,
Change the oil after the first two hours of operation and
every 25 hours thereafter or at least once a year if the
tractor is not used for 25 hours in one year,.
Check the crankcase oil level before starting the engine
and after each eight (8) hours of operation,, Tighten oil fill
cap/dipstick securely each time you check the oil level,.
TO CHANGE ENGINE OIL (See Figs, 11 and 12)
Determine temperature range expected before oil change,,
All oil must meet API service classification SF or SG.
• Be sure tractor is on level surface,
• Oil will drain more freely when warm.
• Catch oil in a suitable container,,
• Remove oil fill cap/dipstick,. Be careful not to allow dirt
to enter the engine when changing oil,,
° Remove drain plug,,
° After oil has drained completely, replace oil drain plug
and tighten securely,
° Refill engine with oil through oii fill dipstick tube. Pour
slowly. Do not overfill,, For approximate capacity see
"PRODUCT SPECIFICATIONS" on page 3 of this
manual
° Use gauge on oil fill cap/dipstick for checking level. Be
sure dipstick cap is tightened securely for accurate
reading,, Keep oil at "FULL" line on dipstick.
OIL FILL
CAPIDIPSTICK
OIL DRAIN
PLUG
FIG. 12
FIG. 11
'17