Filter
Top Products
CUSTO
RESPONSJ IL E$
........ i,J,_J,lJJ
TRACTOR
Always observe safety rules when performing any mainte-
nance°
BRAKE OPERATION
If tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted.
(See "TO ADJUST BRAKE" in the Service and Adjust-
ments section of this manua!).=
TIRES
o Maintain proper air pressure in al! tires (See "PROD-
UCT SPECIFICATIONS" on page 3 of this manual).
° Keep tires free of gasoline, oil, or insect control chemi-
cals which can harm rubber.
° Avoid stumps, stones, deep ruts, sharp objects and
other hazards that may cause tire damage..
BLADE CARE
For best results mower blades must be kept sharp_ Re-
place bent or damaged blades_
BLADE REMOVAL (See Fig. 9)
° Raise mower to highest position to allow access to
blades.
° Remove hex bolt, lockwasher and flat washer securing
blade..
= Install new or resharpened blade with trailing edge up
towards deck as shown_
• Reassemble hex bolt, lock washer' and flat washer in
exact order as shown.
° Tighten bolt securely (30-35 Ft. Lbs. torque).
IMPORTANT: BLADE BOLT IS GRADE 8 HEATTREATED..
NOTE: We do not recommend sharpening blade- but ifyou
do, be sure the blade is balanced_
*A GRADE 8 HEAT TREATED BOLT CAN BE
IDENTIFIED BY SIX LINES ON THE BOLT HEAD.
FIG, 9
TO SHARPEN BLADE (See Fig. 10)
Care should be taken to keep the blade balanced. An
unbalanced blade will cause excessive vibration and even-
tual damage to mower and engine..
• The blade can be sharpened with a file or on a grinding
wheel.. Do not attempt to sharpen while on the mower..
• To check blade balance, you will need a 5/8" diameter
steel bolt, pin, or a cone balancer_ (When using a cone
balancer, follow the instructions supplied with bal-
ancer)..
= Slide blade on to an unthreaded portion of the steel bolt
or pin and hold the bolt or pin parallel with the ground.
if blade is balanced, it should remain in a horizontal
position. If either' end of the blade moves downward,
sharpen the heavy end until the blade is balanced.
NOTE: Do not use a nail for balancing blade_ The lobes of
the center hole may appear to be centered, but are noL
CENTER HOLE
5/8" BOLT
OR PIN
BLADE
FIG. 10
16