Craftsman 580.751651 Pressure Washer User Manual


 
ASSEMBLY
Attach wire support to two lower holes in guide handle
with #10 self-drilling screws and # 10 fiat washers (Fig.
3). The hose minder should betothe leftand gunholder
to the ri_ht. Be sure loop ofsupport ispointing upward.
Place vmyt cap onto gun holder.
VINYL CAP
I
GUIDE
/ HANDL_
/
WIRE
SUPPORT
FIG.3
TO ASSEMBLE REMAINING COMPONENTS
IMPORTANT: YOU MUST ASSEMBLE WAND AND AT-
TACH ALL HOSES BEFORE YOU START ENGINE.
STARTING ENGINE WITHOUT ALL HOSES CON-
NECTED AND WATER SUPPLIED WILL DAMAGE
PUMP,
Remove cap from top of
pump and insert oil fill
cap attached to other
end of yellow waming
tag,
FIG. 4
Screen in water inlet for cleanliness and inspect Inlet
Screen on female connector. Reattach male connector
to water inlet and attach female connector to garden
hose.
Unravel high pressure hose, remove protective cap
from end of hose and check other end of hose to see
that threads are properly covered with teflon tape. If
tape is not properly applied, reapply it so threads are
fully covered. The tape seals the connection from hose
to gun and wand assembly.
Attach fitting with teflontape to gunand wand assembly
(Fig. 6). You may want to spingun. Tighten with adjust-
able wrench to keep hose from twisting.
FIG. 6
Attach the other end of the high pressure hose to high I
pressure fitting on pump (Fig. 7). Tighten with adjust-
abte wrench.
DETERGENT PICKUP TUBE
HIGH PRESSURE
HOSE
Included with this unit is a Quick-Connect fitting you
attach to Water Inlet on pump, The quick-connect
includes two parts -- a Male Connector factory-in-
stalled on water inlet and a Female Connector (Fig. 5).
Remove male connector to inspect Intake Supply
INTAKE SUPPLY OPENING
_R'AKESUPPLY FILTER
MALE
FIG. 5
FEMALECONNECTOR
INLET SCREEN
FIG. 7
,, Attach Detergent Pickup Tube and Filter as shown in
Fig. 7.
o To attach the adjustable nozzle, refer to Operation
section, Fig. 9,
CHECKLIST
Check that fasteners you used to install wheels and
handle are tight. Vibration during operation may
loosen fasteners that are not tight enough,
Check for proper hose connections (high pressure and
water supply) and for tight connections and that there
are no kinks, cuts, or damage to the high pressure
hose.
o Provide proper water supply (not to exceed 140°F).
Be sure to read "Safety Rules" and "Operation" se_
tions before using the pressure washer,