Filter
Top Products
SAFETY RULES
_ CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CANNOT CON-
TACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP, TRANSPORTING,
ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER,
TRAINING:
• Engine exhaust gases contain DEADLY carbon monox-
ide gas. This dangerous gas, if breathed in sufficient
concentrations, can cause unconsciousness or even
death. Operate this equipment only inthe open air where
adequate ventilation is available.
• WARNING: Engine exhaust from this product contains
chemicals, known, in certain quantities, to cause cancer,
birth defects, or other reproductive harm.
• Gasoline is highly FLAMMABLE and its vapors are EX-
PLOSIVE. Do not permit smoking, open flames, sparks
or heat in the vicinity while handling gasoline. Avoid
spilling gasoline on a hot engine. Allow unitto cool for 2
minutes before refueling. Comply withatilaws regulating
storage and handling ofgasoline.
• Locate this pressure washer in areas awayfrom combus-
tible materials, combustible fumes or dust.
• The high pressure equipment isdesigned to be used with
Sears authorized parts only. If you use this equipment
with parts thatdo notcomply withminimum specifications,
the user assumes all risks and liabilities.
= Some chemicals or detergents may be harmful if inhaled
or ingested, causing severe nausea, fainting orpoisoning.
The harmful elements may cause property damage or
severe injury.
• Do not allow CHILDREN to operate the Pressure Washer
at any time.
PREPARATION:
• Operate engine only at governed speed. Running the
engine at excessive speeds increases the hazard of
personal injury. Do not tamper with parts which may
increase or decrease the govemed speed.
• Do not wear loose clothing,jewelry or anything that may
be caught in the starter or other rotating parts.
• Before starting the Pressure Washer in cold weather,
check all parts of the equipment and be sure ice has not
formed there.
• Units with broken or missing parts, or without protective
housing or covers should NEVER be operated.
• The muffler and air cleaner must beinstalled and in good
condition before operating the Pressure Washer, These
components act as sparkarrestors ifthe engine backfires.
• Check the fuel system for leaks or signs of deteriorat{on
such as chafed or spongy hose, loose or missing clamps
or damaged tank or cap. Correct all defects before oper-
ating the Pressure Washer.
OPERATION:
• Do not spray flammable liquids.
• Never aim the gun at people, animais or plants.
• Never allow any part of the body to come in contact with
the fluid stream. DO NOT come in contact with a fluid
stream created by a leak in the high pressure hose.
e High pressure stream of fluid that this equipment can
produce can pierce skin and its underlying tissues, teed-
ing to serious injury and possible amputation.
• High pressure spray can cause paint chips or other par*
ticles to become airborne and fly at high speeds.
= Always wear eye protection when you use this equipment
or when you are in the vicinity where the equipment is in
use.
• Operate the pressure at no more than the PSI fluid
pressure rated for your pressure washer.
• Never move the machine by pulling on the high pressure
hose. Use the handle provided on the top of the unit.
= Always be certain the spraygun, nozzles and accessories
are correctly attached.
• Never use a spray gun which does not have a trigger lock
or trigger guard in place and in working order.
• Use a respirator or mask whenever there is achance that
vapors may be inhaled. Read all instructions with the
mask so you are certain the mask wilt provide the neces*
sary protection against inhaling harmful vapors.
= High pressure spray may damage fragile items including
g!ass. Do not point spray gun at glass when in the jet
spray mode.
= Keep the hose connected to machine or the spray gun
whitethe system is pressurized. Disconnecting the hose
while the unit is pressurized is dangerous.
• Hold the spray gun firmly in your hand before you start
the unit. Failure to do so could result in an injury from a
whipping spray gun. Do not leave the spray gun unat-
tended while the machine is running.
• The cleaning area should have adequate slopes and
drainage to reduce the possibility of a fall due to slippery
surfaces.
• Keep water sprayaway from efectricwiring ortatal electdc
shock may result.
• Do not adjust unloader valve to a pressure In excess of
machine rating.
o Do not secure triggergun in the pull-back (open) position.
= Do not by-pass any safety device on this machine.
= Do not leave trigger closed for more than 5 minutes with
engine running. This could damage the pump.
• The muffler and engine heat up during operation and
remain hot immediately after shutting it down. Avoid
contact with a hot muffler or engine or you could be
severety burned.
MAINTENANCE AND STORAGE:
= Operate and store this unit on a stable surface.
= High pressure hose can develop leaks from wear, kinking,
abuse, etc. Water spraying from a leak is capable of
injecting material into skin. Inspect hose each time before
using it. Check aU hoses for cuts, leaks, abrasions or
bulging ofcover, or damage or movement of couplings. If
any of these conditions exist, replace hose immediately.
Never repair high pressure hose. Replace'it with another
hose that meets minimum pressure rating of your pres-
sure washer,
t_Ik LOOK FOR THIS SYMBOL TO POINT OUT iMPORTANT
SAFETY PRECAUTIONS. IT MEANS "ATTENTION!!! BE-
COME ALERT!!! YOUR SAFETY IS INVOLVED."