Filter
Top Products
1- Screw, 5/16-18 x 2 In.
_ 5116-18x1.00 In.
Parts packed separately in carton (not shown full size)
2 - Ignition Keys
(Attached to engine in plastic bag)
1 - container 5W30 oil
1 - container Fuel
Stabilizer
1 - Crank Assembly
1 - Snow Chute Assembly
CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton and plastic ties
2 - 1/2 inch wrenches (or adjustable
wrenches)
2 - 9/16 inch wrenches (or adjustable
wrenches)
2 - 3/4 inch wrenches (or adjustable
wrenches)
t - Pliers (to spread cotter pin)
1 - Screwddver
1 - Measuring tape or ruler
The figure below shows the snow thrower in
the shipping carton.
The figure below shows the snow thrower
completely assembled.
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit.
Auger drive lever
cable
ly
lever
Lower hand!
=_ Clutch
able
e
assembly
Height
adjust
skids
/
5