Filter
Top Products
iNSTRUCTiONS FOR ALL TRACTORS
STEP 24: MOUNT SCOOPTOTRACTOR
(SEE FIGURE 23)
Align the scoop with the side plates on the front of the
tractor. Lift the rear of the scoop and slide the notches
in the scoop frame onto the bolts or pins in the tractor
side plates. Stand on the left side of the tractor and
push down on the scoop dump handle until the holes
in the scoop frame and the holes in the side plates are
aligned. Install the attachment rod through the holes
from the left side and secure it with a long hairpin
cotter (X).
LONG
HAIRPIN
COTTER (X)
/
DUMP HANDLE
BO_ OR PiN
• _ ATTACHMENT
ROD
SCOOP _%
ASSEMBLY
FIGURE 23
STEP 25: ADJUSTTILT BRACKET AND PIN STOP BRACKET
(SEE FIGURE 24)
Lower the scoop assembly onto a smooth level surface.
For normal use, let the bottom of the bucket rest flat on
the ground. For more aggressive scraping action, place
1/4" shims under the rear of the bucket at each end.
If they are tightened, slightly loosen the two smaller
bolts in the tilt bracket. If they are tightened, slightly
loosen the four bolts in the pin stop bracket.
Swing the tilt bracket forward and position the pin stop
bracket so the end of the dump control pin inserts into
the hole in the tilt bracket.
Adjust the pin stop bracket so that it is square with the
bucket leaving a small gap between the pin stop bracket
and the tilt bracket. The taper on the end of the pin
should now extend all the way through the tilt bracket.
TIGHTEN the bolts and nuts in the pin stop bracket
TIGHTEN the two bolts and nuts in the tilt bracket.
SMALLER BOLTS
TILT BRACKET /
PIN STOP BRACKET
FIGURE 24
15