Filter
Top Products
STEP 22: iNSTALL FRAME BRACE
(SEE FIGURE 21)
* Install the frame brace between the side plates using
two 1/2" x 1-3/4" bolts (B), large 1/2" large washers
(11),1/2" spacers (W) and 1/2" nylock nuts (O). Fasten
the brace to the second from bottom holes in the side
plates. Tighten.
* Tighten 3/8" bolts (E) in side plates only until they are
snug and the lock washers are flattened.
* Skip to step 24 on page 15.
1/2" x 1-3/4"
HEX BOLT (B)
112" SPACER (W)
/
112" LARGE
WASHER (ll)
1/2" NYLOCK NUT (O)
FRAME BRACE
FIGURE 21
GARDEN TRACTORS WiTH DUAL
SUSPENSION BRACKETS
STEP 23: iNSTALL SiDE PLATES
(SEE FIGURE 22)
* Remove any bolts present in the mounting holes on
the left side of the tractor frame. Do not remove bolts
from right side of frame until left side plate has been
installed.
Install the left (short) side plate with the pin to the
outside using two 3/8" x 1" hex bolts (E) and 3/8" lock
washers (BB). Tighten only until bolts are snug and
lock washers are flattened. Repeat for the right side
plate.
• Install a 3/4" washer (JJ) and a long hairpin cotter
(X) to the pin in each side plate. Remove them while
mounting the scoop.
LEFT (GT)
SIDE PLATE
_" "" #"_'_ (2) 318"LOCK
._ WASHERS (BB)
(2) 3/8" x 1"
LONG HEX BOLTS (E)
HAiRPiN 3/4" WASHER (JJ)
COTTER (X)
FIGURE 22
14