Filter
Top Products
• Assemble a shoulder bolt arid 3/8" hex lock nut to
the R.H. side of the tractor fi'ame, using the first
empty hole to the rear of the R.H. hanger bracket.
See figure 7
Replace the engine puney keeper on your tractor
with the new pulley keeper supplied with the snow
blower. Attach the keeper to the frame using the
original bolt, washer and nut. See figure 7.
NOTE: Some tractors may already be equipped
with an identical pulley keeper.
ORIGINAL BOLT,
NUT AND WASHER
SHOULDER BOLT
R.H. HANGER BRACKET
FIGURE7
-\\
RIGHT SIDE VIEW
ENGAGEMENTROD
CLUTCH ARM
TRUNNION
/
5/64" HAIRPIN
CO'I-rER
\
SUSPENSION ARM
FIGURE8_ RIGHT SIDE VIE.W
Be sure that the loose end of the engagement rod
is lifted up toward the front of the tractor (as shown
in figure 9) when performing the next operation.
You can temporarily support the rod using a rubber
band tied to the engine pulley keeper.
Attach the snow thrower's clutch/idler assembly to
the tractor frame by sliding the notched arms at the
rear of the assembly onto the two shoulder botts
assembled to the inside of the tractor frame. Lift
the front of the assembly, fitting the sides into the
R.H. and L.H. hanger brackets. Attach the assem-
bly to the brackets using two pivot lock pins and
1/8" hairpin cotters. See figure 9.
INSTALLING THE CLUTCH/IDLER ASSEMBLY ON
TRACTORS WITH MANUAL ATTACHMENT
CLUTCHES (Use these instructions if your tractor
has an attachment clutch lever on the dash panel
for starting and stopping the mower deck.)
• Move the attachment clutch lever on the dash
panel to the disengaged (down) position.
• Screw the trunnion onto the end of the engagement
o-red as shown in figure 8.
Locate the clutch arm which is found underneath
the right hand side the tractor, just to the inside of
the suspension arm. This is the arm that the mower
clutch rod was connected to. This arm will move
forward and backward if the attachment clutch lever
on the dash panel is moved.
Position the engagement rod to the inside of the
clutch arm and insert the drilled end of the rod
through the arm. Secure with+a 5/64" hairpin cotter.
See_igure 8.
1/8" HAIRPIN COTTER
PIVOT LOCK PIN
FIGURE9
ROD
RIGHT SIDE VIEW