Craftsman 486.248381 Snow Blower User Manual


  Open as PDF
of 40
 
8
STEP 4: (SEE FIGURE 4)
• Assemble a shoulder bolt (P) and a 3/8" washer (X)
to the outside of R.H. side plate, securing it with a
3/8"angednut(BB).RepeatforL.H.sideplate.
FIGURE 4 RIGHT SIDE VIEW
FIGURE 3 RIGHT SIDE VIEW
5/16"
NYLOCK
NUT (CC)
5/16" x 1"
CARRIAGE BOLT (N)
ENGINE MOUNTING
PLATE
(4) 1/2" WASHERS (V)
(3) 3/8" FLANGE NUTS (BB)
(3) 3/8" x 1"
CARRIAGE
BOLTS (K)
SEE NOTE
3/8" WASHER (X)
SHOULDER
BOLT (P)
3/8" FLANGED
NUT (BB)
INSTALL SIDE PLATES
STEP 3: (SEE FIGURE 3)
• FastentheR.H.SidePlate(bendfacingout)tothe
front three holes in the tractor frame using three
3/8" x 1" carriage bolts (K), three 1/2" washers (V)
(seenote)andthree3/8"angenuts(BB). For the
rear hole, use a 5/16" x 1" carriage bolt (N), a 1/2"
washer (V) and a 5/16" nylock nut (CC). Place the 1/2"
washers (V) between the tractor frame and the side
plate. Repeat for L.H. side plate.
• Reinstallthebrowningshieldontothetractorframe
using the original screws.
NOTE: If there is an engine mounting plate (shown with
dottedlines)leavethe1/2washerofftheboltthatgoes
through the plate.
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
STEP 5: (SEE FIGURE 5)
• Removethebolt,ifpresent,intheholedirectlybehind
the brake rod on the left side of the tractor frame.
• AttachtheL.H.HangerBracket(tubefacingout)tothe
hole using a 5/16" x 3/4" self threading bolt (I).
• Installaroundheadshoulderbolt(Q)intothehole
that is 9-1/2" to the rear of the bolt you just installed.
Secureitwitha3/8"angenut(BB)ontheinsideof
the frame.
FIGURE 5 LEFT SIDE VIEW
5/16" x 3/4" SELF
THREADING BOLT (I)
L.H. HANGER
BRACKET
BRAKE ROD
3/8" FLANGED
NUT (BB)
SHOULDER
BOLT (Q)
5/16" x 3/4" SELF
THREADING BOLT (I)
R.H. HANGER
BRACKET
RIGHT END OF
BRAKE ROD
3/8" FLANGED
NUT (BB)
SHOULDER
BOLT (Q)
STEP 6: (SEE FIGURE 6)
• Removethebracket,ifpresent,fromtheholedirectly
behind the end of the brake rod on the right side of
the tractor frame. Store the bracket and bolt.
• AttachtheR.H.HangerBrackettotheholeusinga
5/16" x 3/4" self threading bolt (I).
• Installaroundheadshoulderbolt(Q)intothehole
that is 9-1/2" to the rear of the bolt you just installed.
Secureitwitha3/8"angenut(BB)ontheinsideof
the frame.
FIGURE 6 RIGHT SIDE VIEW
 previous next