Craftsman 486.248381 Snow Blower User Manual


  Open as PDF
of 40
 
18
FIGURE 40 VIEWED FROM UNDERNEATH
FIGURE 39
STEP 40: (SEE FIGURE 40)
• Assembletheshort"V"beltontotheenginepulley
and then onto the large pulley on top of the clutch/idler
assembly. The belt must be placed to the inside of the
engine pulley keeper, the idler pulley and the keeper
bolt located beside the large pulley.
IMPORTANT: Do Not assemble the "V" belt around the
outside of the engine pulley keeper or the keeper bolt.
• Go to step 48 on page 21.
STEP 39: (SEE FIGURE 39)
• Removetheenginepulleykeeperfromthesideof
thetractorframebyremovingthewasherandnut
that secure the keeper. Attach the new pulley keeper
supplied with the snow thrower, reusing the original
bolt, washer and nut.
NOTE: Some tractors may already be equipped with a
pulley keeper that is identical to the new one supplied.
• Attachtheclutch/idlerassemblytothetractorframe
asfollows.Hooktheassembly'snotchedarmsonto
the two shoulder bolts you assembled to the inside
of the tractor frame. Lift the front of the assembly and
attach it to the R.H. and L.H. hanger brackets using
twopivotlockpins(MM)and1/8"hairpincotters(KK).
NEW ENGINE PULLEY KEEPER WITH
ORIGINAL BOLT, NUT AND WASHER
PIVOT LOCK PIN (MM)
(use second hole)
1/8" HAIRPIN COTTER (KK)
ENGINE
PULLEY
KEEPER BOLT
IDLER
PULLEY
ENGINE
PULLEY
KEEPER
Left Side
of Tractor
CLUTCH/IDLER ASSEMBLY
 previous next