Filter
Top Products
14
1/4" x 1-1/4"
HEX BOLT
1/4" LOCK
NUT
1/4" x 3/4"
HEX BOLT
1/4" LOCK
NUT
LOWER ROD
(BENT)
FIGURE 20
FIGURE 19
Attach the last lower support rod to the • outside of
the top angle support using two 1/4" x 3/4" hex bolts
and 1/4" lock nuts. TIGHTEN, then back nut off until
rods freely pivot. See gure 19.
NOTE: Cart bag not shown for clarity.
1/4" x 3/4" HEX BOLT
1/4" LOCK NUT
FRONT ROD
(STRAIGHT)
LOWER ROD
(BENT)
FIGURE 18
Attach the front (straight) support rod to the • outside
of the top angle support and a lower (bent) support
rod to the inside using two 1/4" x 3/4" hex bolts and
1/4" lock nuts. TIGHTEN, then back nut off until
rods freely pivot. See gure 18.
NOTE: Cart bag not shown for clarity.
Attach the braces to the front support tube using two •
1/4" x 1-1/4" hex bolts and 1/4" lock nuts. TIGHTEN.
Do not over tighten and compress support tube.
See gure 20.
NOTE: Cart bag not shown for clarity.