Filter
Top Products
13
BEND
CART COVER
SUPPORT ROD
ROPE
1/4" x 1-1/4" HEX BOLT
1/4" LOCK NUT
FIGURE 16
FIGURE 17
Slide the second lower support rod through outer •
edge of the cart cover. Slide an end of the rope onto
the rod end as it approaches each gap in edge. The
bend in the rod must face in the direction shown in
gure 16.
CENTER LOOP
FRONT
SUPPORT
ROD
LOWER
SUPPORT
ROD
CENTER LOOP
CART COVER
DOUBLE LOOPS
FRONT
SUPPORT
TUBE
CART COVER
CART COVER ASSEMBLY
Slide the front support tube through the double loops •
located near the front of the cart cover. See gure 14.
FIGURE 14
FIGURE 15
Slide the front (straight) support rod through the •
center loop (located in the top of the cart cover)
closest to the front of the bag. Slide a lower support
rod (bent) through the center loop behind the front
rod. See gure 15.
Secure front support tube to top angle support •
using two 1/4" x 1-1/4" hex bolts and 1/4" lock nuts.
TIGHTEN. Do not over tighten and collapse support
tube. See gure 17.
NOTE: Cart bag not shown for clarity.