Filter
Top Products
11
3/8" x 1"
HEX BOLT
3/8" x 3"
HEX BOLT
3/8" NYLOCK NUT
HOSE HANGER
ROD
Attach the engine mounting plate to the tongues •
using two 3/8" x 3" hex bolts in the back holes, two
3/8" x 1" hex bolts in the front holes and four 3/8"
nylock nuts. See gure 9.
HINT: For easier assembly, support the rear tongue with
a block of wood.
CLAMP
HOSE
HOSE ADAPTER
(NOZZLE)
FIGURE 9
FIGURE 10
FIGURE 11
Place the hose hanger rod down into the hose •
hanger bracket on the impeller housing assembly.
See gure 10.
Place a hose clamp onto the end of the hose. Push •
the hose onto the hose adapter (nozzle). Tighten the
hose clamp onto the hose and hose adapter. Do not
collapse the hose adapter when tightening the clamp.
See gure 11.
The remaining hose clamp will be used later to fasten •
the hose to the deck adapter.