5
SAFETY INSTRUCTIONS
MAINTENANCE & STORAGE
Never tamper with safety devices. Check their proper operation •
regularly.Refertothemaintenanceandadjustmentsectionsof
this manual.
Before cleaning, repairing, or inspecting machine disengage all •
controlleversandstoptheengine.Waituntiltheauger/impeller
come to a complete stop. Disconnect the spark plug wire and
ground against the engine to prevent unintended starting.
Check bolts and screws for proper tightness at frequent intervals •
to keep the machine in safe working condition. Also, visually
inspect machine for any damage.
Do not change the engine governor setting or over-speed the •
engine.Thegovernorcontrolsthemaximumsafeoperatingspeed
of the engine.
Snowthrowershaveplatesandskidshoesaresubjecttowear•
and damage. For your safety protection, frequently check all
components and replace with original equipment manufacturer’s
(OEM)partsonly.“Useofpartswhichdonotmeettheoriginal
equipment specifications may lead to improper performance and
compromisesafety!”
Check control levers periodically to verify they engage and disen-•
gageproperlyandadjust,ifnecessary.Refertotheadjustment
section in this operator’s manual for instructions.
Maintain or replace safety and instruction labels, as necessary.•
Observe proper disposal laws and regulations for gas, oil, etc. to •
protect the environment.
Prior to storing, run machine a few minutes to clear snow from •
machineandpreventfreezeupofauger/impeller.
Never store the machine or fuel container inside where there is an •
open flame, spark or pilot light such as a water heater, furnace,
clothes dryer etc.
Always refer to the operator’s manual for proper instructions on •
off-season storage.
Check fuel line, tank, cap, and fittings frequently for cracks or •
leaks. Replace if necessary.
Do not crank engine with spark plug removed.•
AccordingtotheConsumerProductsSafetyCommission(CPSC)•
andtheU.S.EnvironmentalProtectionAgency(EPA),thisproduct
has an Average Useful Lifeofseven(7)years,or60hoursof
operation. At the end of the Average Useful Life have the machine
inspected annually by an authorized service dealer to ensure that
all mechanical and safety systems are working properly and not
wornexcessively.Failuretodosocanresultinaccidents,injuries
or death.
DO NOT MODIFY ENGINE
Toavoidseriousinjuryordeath,donotmodifyengineinanyway.
Tampering with the governor setting can lead to a runaway engine and
cause it to operate at unsafe speeds. Never tamper with factory setting
of engine governor.
NOTICE REGARDING EMISSIONS
Engines which are certified to comply with California and federal
EPAemissionregulationsforSORE(SmallOffRoadEquipment)are
certified to operate on regular unleaded gasoline, and may include
thefollowingemissioncontrolsystems:EngineModification(EM),
OxidizingCatalyst(OC),SecondaryAirInjection(SAI)andThreeWay
Catalyst(TWC)ifsoequipped.
SPARK ARRESTOR
Ifasparkarresterisused,itshouldbemaintainedineffectiveworking
orderbytheoperator.IntheStateofCaliforniatheaboveisrequired
bylaw(Section4442oftheCaliforniaPublicResourcesCode).Other
states may have similar laws. Federal laws apply on federal lands.
A spark arrester for the muffler is available through your nearest Sears
Parts and Repair Service Center.
WARNING
This machine is equipped with an internal combustion engine and
should not be used on or near any unimproved forest-covered,
brush-coveredorgrass-coveredlandunlesstheengine’sexhaust
system is equipped with a spark arrester meeting applicable local or
statelaws(ifany)