Craftsman 247.29931 Tiller User Manual


 
4. Snapthe cablehousingclips intothehandleassemblycable
mount.Theredclip(reversecable)fitsinto thetop positiononthe
handleassembly,whiletheblackclip (forward/clutchcable)feeds
intothelowerpositiononthe handleassembly.See Figure3.
5. Clipthecablesintothecableguideslocatedon the handle
assemblypanelas seenin Figure4.
MOVING THE TILLER OFF THE SKID
Torollthe tilleroffthe shippingplatform,putthewheelsinfreewheel,if
theyarenotalreadyfromthefactory,asfollows:
1. Placea sturdyblockunderthetransmissiontoraiseonewheel
about1"off theground.Removetheclickpinfromthe wheelhub
andwheelshaft.SeeFigure5.
2. Slidethewheelfullyinwardon the wheelshaft. Reinstalltheclick
pinthroughthewheelshaftonly(notthroughthewheelhub).See
Figure5.Thewheelshouldnowspinfreely(freewheel)on the
wheelshaft.Repeatwiththe otherwheel.
3. Usethe handlebarto liftand pullthetillerbackwardstoa flat
area.
NOTE:Beforestartingthe engine,the wheelsmustbe placedinthe
WHEELDRIVEposition(pins throughwheelhubsandwheelshaft).
Thisprocedureis describedintheoperationsectionunderwheeldrive
pins.
f
Red
Reverse
Figure4
f
Click Pin
Remove the click pin
from the wheel hub.
(WHEEL DRIVE position)
Slide the wheel fully
inward on the wheel shaft.
Reinstall the click pin.
(Freewheel position)
Figure3
Figure5
J
9