Filter
Top Products
KNOW YOUR RIDER COOLING SYSTEM
Read this owner's manual before operating.
Compare the illustration below with your rider cooling system to familiarize yourself with the various
features and their locations.
POWER SWITCH Controls the power
to the system's pump.
FILL CAP Used to seal the water tank.
Removal permits the filling of the water
tank,
BASKET FILTER (Located under fill
cap) Catches large particulate matter
to ensure long life of the inline filters.
ADJUSTMENT VALVE Controls the
water flow to the nozzle.
"POWER UNIT The power center of the
system.
DRAIN PLUG Allows the user to drain
the water tank.
BEFORE STARTING
• Use end of assembly checklist to verify
that alI instructions have been properly
completed.
• Remove fill cap on power unit and fill with
DRINKING WATER through the basket
filter until tank is filled to approximately 1"
below the bottom of the basket filter.
• Add 5 drops of household bleach to the
water tank before the first use and every
fourth use or once a month (whichever
comes first) after that.
• Replace cap and hand tighten. This is a
pressurized system and requires that
the cap is sealed,
IMPORTANT: This unit is designed to oper-
ate with DRINKING WATER ONLY.
IMPORTANT: Do not operate rider cooling
system with tractor headlights in the ON posi-
tion. Excessive load on tractor's battery will
result in premature drainage.
NOTE: In event that the tank is overfilIed, you
may experience water streaming from the
nozzle. If this occurs, drain excess water from
tank and run unit until desired mist is achieved
prior to operating tractor.
]4