Filter
Top Products
Step 2
• Using a supplied cable tie (J) organize any
excess length of supply tubes and stow
behind battery (or along fuel tank if
equipped). Secure supply tubes to
electrical supply lines of tractor at
convenient locations to prevent line
damage during tractor operation.
• Using remaining cable ties (J) secure
supply tubes to tractor frame along length
under tractor body.
IMPORTANT: Use care not to over tighten
cable ties (J) and pinch supply lines as system
will not function properly. Cable ties are used
as a means to route lines safely away from heat
and possible pinch points during tractor opera-
tion. Following paths of your tractor's electrical
supply lines ensures the best possible results.
• Reconnect negative (-) battery terminal to
tractor electrical system.
Checklist
Before you operate your rider cooling
system, please review the following
checklist to ensure that you will obtain the
best performance from your system.
• Make sure all assembly instructions have
been completed with all bolts and nuts
tightened.
• Make sure hose connections at the filters
have been made and are fully engaged.
• Make sure electrical connection has been
made and is secure.
• Check routing of supply lines and make
sure they do not interfere with pedals,
pulleys, or belts.
• Check supply lines in engine compartment
and ensure they are safely routed away
from the engine.
• Check the supply lines as they exit the
power unit and ensure the bend is
sufficient and does not kink the hoses.
• Check the misting nozzle assembly to
ensure it does not interfere with tractor
controls.
• Turn tractor key to "ON" position and turn
cooling system power unit on.
• Confirm that the cooling system
pump starts.
• Confirm the flow of air from the
cooling nozzle.
• Open the tractor hood and
ensure that filter connections
are maintained.
You are now ready to enjoy the benefits of your
cooling system.
Proceed to the OPERATION section of this
manual to begin using.
]3