Filter
Top Products
Tools Required
½" Socket Wrench w/Extension
Allen Wrenches
Power Drill
Adjustable Wrench
Mounting Power Unit To Tractor
NOTE: If there is a 2 or 3 bin bagger installed
on your tractor, you will need to remove the
bagger from the tractor before proceeding.
Leave the bagger bracket mounted to the vehi-
cle. After cooling system is installed, bagger
may be reinstalled.
Step 1
• Raise the tractor seat and remove the seat
springs using a ½" socket wrench. Set
aside springs. (Save bolts in the event you
want to reinstall seat springs without the
bracket.)
With bracket in place, assemble springs
to tractor using the new 5/16" x 1-1/4"
bolts (A) and 5/16" flat washers (B) sup-
plied with the cooling system. Tighten
using moderate force. Do not over
tighten.
Step 2
• With tractor seat still in the raised posi-
tion, slide power unit in-between the ears
of the mounting bracket. Power unit
should rest on alignment tabs.
Install mounting bracket (CC) by placing
hooks of bracket under lip of tractor body.
Rotate into position. Slots in bracket
should line up with seat spring mounting
locations.
Align holes, and attach power unit to
mounting bracket using four cap screws
(C), eight washers (D), and four nylock
nuts (E).